Astm e 331 pdf

BDG utilizes professional testing equipment that is calibrated to each specific testing standard for accurate results. Our field consultants are properly trained and knowledgeable of all testing standards. BDG has extensive knowledge of most building systems and specializes in forensic water intrusion investigations.

This allows us to not only properly test fenestrations on new construction projects, but also pinpoint the cause of any test failures and provide accurate recommendations to achieve successful testing results.

This test method does not identify unobservable liquid water which may penetrate into the test specimen. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. BDG utilizes professional testing equipment that is calibrated to each specific testing standard for accurate results.

These factors should be fully considered prior to specifying the test pressure awtm to be used. Building Diagnostics Group, Inc. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Failures during quality assurance new construction testing can result in unnecessary delays that impact your bottom line.

BDG has extensive knowledge of most building systems and specializes in forensic water intrusion investigations. Most generic specifications call for a minimum testing pressure of 6. Some designs are more sensitive than others to this upward moving water. MISSION Professional services based on accurate information that helps you or your company make the right decision regarding your project or asset.

Professional services based on accurate information that helps you or your company make the right decision regarding your project or asset. Some designs are more sensitive than others to this upward moving water. Note 2: This test method does not identify unobservable liquid water which may penetrate into the test specimen. Facades ; Phone: Fax: Email: info document-center. These are identified with italics below:.

Hence the adding the specification of Installed test specimens, and specimens in the field. Included diagrams show these differences. In short, the is easier to comply with in the field. It is difficult to find these and other differences without actually placing the two standards next each other, page by page. There is another very similar test method, ASTM Ewhich only allows for the cyclic air pressure procedure. It is also interesting to note that there are two AAMA standards that refer to these ASTM standards for most of their procedures and are performed in nearly identical fashion.